Did you update Betaflight and forgot to backup your BNF factory tuning and custom settings?
Use our GoogleDrive database to download the latest version of our hardware schematics where you can also find the correct Betaflight target or to download and factory reset your iFlight BNF!
Link: https://drive.google.com/drive/folders/1r3MNTBNYSzGeRXQg45j4IJVoW1Xjk7Y0
Wiring diagram:
Check our Google Drive and search for your product. If you are not sure what product or version you have, check your order, search for your product in our store for specifications or connect the Betaflight Configurator to your FC and see what the status line (Log) says.
Betaflight UPDATE?
To update your Betaflight firmware, download the latest version of the Betaflight Configurator and install the correct target via the Configurator. DO NOT FLASH UNIFIED TARGETS like STM32xxx targets, always use our IFLIGHT_ targets that come with custom default settings to reset the IO parameters. Use our wiring diagram, our website product page or check the current Betaflight version that has already been displayed on your flight control in the Betaflight Configurator status box or CLI to identify the correct target!
Betaflight Flashing Article:
https://www.youtube.com/watch?v=dvmIVM-2N74
How do I identify my hardware in Betaflight?
If your BNF or Flight Controller is still on stock firmware, you can also identify the correct target (firmware) in the top left corner of the Betaflight log. In the example below, the correct target for this particular FC would be "IFRC/IFLIGHT_F745_AIO" and can be updated in the "Update Firmware" tab.
Factory landfills:
WARNING: Make sure you are using the same version of Betaflight before applying the dump OR update your Betaflight to the latest version and adjust the settings as needed! It is not recommended to paste old dumps into newer versions of Betaflight!
To restore factory settings with our factory dump:
ATTENTION: Make sure IF you have flashed or flashed your Betaflight firmware to apply the custom defaults immediately. This prompt will appear automatically after a successful flash and a subsequent reboot of your Flight Controller. If this does not happen, something has gone wrong!
Step 1: Copy the contents of our *.txt file (GoogleDrive link above)
Step 2: Open Betaflight Configurator and go to CLI (bottom of left column menu)
Step 3: Paste into CLI (command line) and press Enter key
Step 4: Type "save" and press Enter key to save your settings!
Factory settings have been restored!
Step5: To recalibrate your gyro in the Betaflight configurator, go to the "Setup" tab.
Step 6: Position your drone as perfectly level as possible and press "Calibrate"
Article about gyro calibration and its effects in Angle mode:
https://www.youtube.com/watch?v=otJNzZrE-yk
WARNING: Test flight in a confined area and do not endanger the drone or yourself or even other people! If you play with the settings of your drone, we cannot take responsibility for it! So always make sure you know what you are doing and double check the settings it is on! Check the motor temperature, flight stability and make sure there are no issues before flying over water or hitting trees at full power!
